View source for Main Feactures and Functions for the H-series.

== '''Main Feactures and Functions for the H-series''' ==
[[File: Cats2.jpg|200px|thumb|right|product sample]]
*'''Accurate Frame Drive'''
For stable frame driving,special stepping (pulse) motors are used. These motors feature an almost permanent life and pin-point accuracy.

*'''Automatic Needle Bar Selector (Pantented)'''
Colors (needle bars) can be selected up to 99 times in any desired sequence.

*'''Threas Tension Releasing Device (Patented)'''
During sewing. Tension is automatically released an all unused threads.

*'''Independent Take-up Lever Drive System'''
The take-up lever only for the needle bar being used, operates while the other levers are at rest: this prevents the threasd from being entangled.
This system also allows the threads to run smoothy for constant ATH trimming.

*'''Both Binary and Ternary Tape formalts can be used'''

*'''Speed Change'''
Speeds can be automatically changed between High and Low ranges by tape code data: key operations also allow you to adjust the speeds as required.

*'''Desing Coordinate'''
A desing can be mirrored both horizontally and vertivally and also rotated in 90-degree increments: 8-diferrent positions can be createcd

*'''Memory System'''
Up to 99 desings can be memorized in this system with the remaining capacity displayed in the stitches. (A standard 128.000- stitch memory card is included.)

*'''Automatic Repeat'''
A desing can be repeatedly stitche-d up to 9 times during memory operation.

*'''Frame back function'''
When a design is damaged by thread Breakage, the frame can be stitched back for repairs up to 500 stitches during memory and tape operation. Also, as soon as the single-head operation to restitch the damaged part is completed, the other heads resart sewing.

*'''Frame Forward'''
The frame can be stepped forward without stitching up to the end of the design.

*'''Scaling Up/Down Function'''
A design can be scaled up or down in 1-% increments from 50% up to 200%.

*'''Return Origin'''
Simple key operations return the frame to the design starting point.

*'''Offset Function'''
In addition to the design starting point, a secondary starting point can be set for automatic operation: this function facilitates frame changing, thread trimming, etc.

*'''Display Function'''
Various messages are digitally displayed: R.P.M., available memory, and stitch count, stop factors emergency stop codes, etc.

*'''Automatic Thread Trimming Device (ATH)'''
This device has the function of trimming both upper and under threads automatically at the same time by pre-punched tape code when embroidery is completed, color change is performed, or stitching is jumped from one design to another.