Embroidery Troubleshooting

From Embroidery Machine WIKI
Revision as of 20:31, 15 August 2013 by Mreagan (talk | contribs) (update)
Jump to navigation Jump to search

When an embroidery machine is not running at optimal performance there are certain Embroidery Troubleshooting tips one can follow to attempt to get the embroidery machine to run properly.

Before calling your embroidery machine technician, this troubleshooting guide might be used to fix basic problems.

When an embroidery machine becomes problematic chances are its not the machine but instead more than likely operator errors, design problems, hooping problems, thread or needle issues, etc. Before mechanically doing anything to your machine, one should check for most of the common issues.

Symptoms and Resolutions

Thread Breaks

One of the most common problems encountered in daily embroidery production is a thread break. This section covers the main reasons that a thread will break and how to minimize thread breaks. The six problem areas involve: thread, needles, materials, design, mechanics and operator technique.

Thread.

Needle.

Materials.

Design.

Mechanical.

Technique.

Needle Breaks

Needle breaks are another common issue. Here are some likely causes:

• The needle may be dull and needs to be changed. If the needle has trouble getting through the fabric, it will eventually cause the needle to break.

• Make sure the needle is inserted properly. If it is not inserted all the way into the needle bar shaft, it could come loose while sewing and break.

• Make sure the hook timing is correct. If the machine is not timed properly, the needle may hit the hook, which could cause it to break.

Bird Nesting

There are three primary causes to birdnesting: unbalanced tension, flagging, or problems with the hook assembly.

Tension problems. Check the thread path to insure the machine is threaded properly. Then sew a tension test such as an 18mm capital "I" test.

Flagging problems. Check to make sure the fabric is framed properly. It should be tight. Also, make sure there is not a significant gap between the hoop assembly and the sewing arm.

Hook assembly problems. If there is a problem with the hook assembly, look at two things. Either the hook positioning finger is mounted too close to the hook basket, or the hook basket does not allow the sewing hook to spin freely.

Skipping Stitches

Vibrations and Noise

When an embroidery machine vibrates excessively then it might mean the machines is not on a flat surface or is not properly leveled.


Tools Recommended