Melco USB Upgrade

From Embroidery Machine WIKI
Jump to navigation Jump to search
Floppy To USB upgrade for Melco
Floppy To USB upgrade for Melco
Melco EMC/EMT Single-head floppy drive replaced with USB
Melco boot disk floppy replaced with USB stick boot disk
Melco EMC/EMT Multi-head with USB Upgrade
Melco EMC/EMT Multi-head with USB Upgrade Boot Disk

The Melco USB upgrade uses the Floppy To USB device

This can be a replacement for the Ethernet system and the floppy drive that Melcos typically use.

Connection

Melco connectors.jpg

The first step it to verify that the Melco machine has the connectors for a floppy drive. If the machine already has a floppy drive, then the drive model USB-A001 from http://www.BuyUSBFloppyUpgrade.com.

The connectors are located on the main mother board. On EMC single heads, this board is located behind the left hand side plastic cover. On 4 heads, this board is at the back of the machine underneath the covers.

If the Melco machine is a black head Tajima type, then the floppy to USB will not work.

If the machine is already equipped with a floppy then follow the cables to where they connect to the mother board. The same data and power cable that connect to the follow can be used on the Floppy To USB upgrade.

Melco data power.jpg

Installation

If the Melco machine is already equipped with a Floppy Drive, then the Floppy To USB upgrade will replace the Floppy Drive seamlessly. Just remove the old floppy and install the Floppy To USB in the reverse order.

If the machine does not have a floppy.

Melco pin info.jpg

Replacement

The Floppy to USB can replace:

  • Premier Keyboards
  • Melco Floppy Disks
  • Melco Ethernet System
  • EDS