Floppy Disk Drive to USB Upgrade Information

From Embroidery Machine WIKI
Jump to navigation Jump to search
Two Floppy To USB drives - slim size (on left) and standard
Two Floppy To USB drives - slim size (on left) and standard

The FloppyToUSB device is a floppy disk drive emulator that is designed to replace a 3 1/2 floppy drive with a USB drive.

This Floppy Disk Drive to USB Upgrade Information is intended for people looking to replace their Floppy Disk Drives with USB drives.

For {{#if:a complete list of Known Working Models|a complete list of Known Working Models|other uses}}, see Floppy_To_USB#Known_working_Models{{#if:|{{#if:|, [[:{{{3}}}]], {{#if:|[[:{{{4}}}]], and [[:{{{5}}}]]|and [[:{{{4}}}]]}}| and [[:{{{3}}}]]}}}}.

Known Working Models

The first step is to check if the machine or floppy is on the Known Working Models list.

A complete list of known working USB upgrades can be found at the Known Working USB Models list.

If the machine is on that list, order the corresponding drive from that list at http://www.BuyUSBFloppyUpgrade.com

For example, HAAS HL2 Lathe is listed as drive USB-A001. Drive USB-A001 in that example should be ordered from the above link.

Many of the entries in that list are models of floppy drives and not equipment models. If both the machine and the floppy drive are listed, always go with the USB code listed for the machine and not the drive. Drives are configurable and one type of drive might have many configurations.

Unknown Models

Floppy Drive Jumpers
Floppy Drive Jumpers
Floppy Model Numbers
Floppy Model Numbers

If the machine make or model is not on the list then there are a few things that need to be known in order to get the correct drive.

The following questions and answers should be sent to PLRElectronics in order to determine the correct model.

This list has been written in the order of importance per question. Please answer as many of the questions as possible keeping in mind the most important questions are first. Please answer as many of the following

  • What is the exact Make and Model of the machine?
  • What is the exact make and model of the current drive in the equipment or, is there a known make and model of drive that does work?
  • Are there any Jumpers on the drive? If so, please take a picture of them as shown in the example to the right.
  • Does the machine use both 720 and 1.44 megabyte floppy disks or only one or the other?
  • What operating system does the machine run off of?
  • Approximately how old is the machine?

Further Questions

If your machine or drive is not on the list, then contact PLRElectronics and they can tell you exactly what drive to order.

Retrieved from "http://wiki.embroiderymachine.com/index.php?title=Floppy_Disk_Drive_to_USB_Upgrade_Information&oldid=3885"